Add Users to the Pre-Windows 2000 Compatible Access Group
IN THIS TASK
SUMMARY
Setting Up the 2000 Compatible
Access Group in the Active Directory Users and Computers Snap-in
Setting up the 2000 Compatible
Access Group at the Command Line
Troubleshooting
REFERENCES
SUMMARY
This step-by-step article describes how the Pre-Windows
2000 Compatible Access group is used, why it is needed in a mixed-mode
domain, and how to set up the group up by using the Active Directory Users
and Computers snap-in and command line.www.tartoos.com
Set up procedures that you run in the graphical user interface (GUI) are
done by a member of the domain administrators group on a domain controller
(DC) that is running Windows 2000 in a mixed-mode environment.
Set up procedures that you run at a command prompt are done by a member of
the domain administrators group on a DC that is running Windows NT 4.0 RAS
(or RRAS) server in a mixed-mode environment.www.tartoos.com
Setting Up the 2000 Compatible Access Group in the Active
Directory Users and Computers Snap-in
By default, the Everyone special group is a member of the
Pre-Windows 2000 Compatible Access group. This enables any RAS caller to
be authenticated by the Windows NT 4.0 RAS server. If the Everyone special
group has been deleted from the Pre-Windows 2000 Compatible Access:
www.tartoos.com
1.
Click Start, point to Programs, point to Administrative
Tools, and then click Active Directory Users and Computers.
2.
In the console tree, click the server you want to work
with.
3.
In the console tree, click the BUILTIN folder.
4.
In the Details pane, right-click the Pre-Windows 2000
Compatible Access group, and then click Properties.
5.
On the Members tab, click Add.
www.tartoos.com
6.
In the Select Users, Contacts, Computers or Groups dialog
box, click the Domain Users group, click Add, and then click OK.
7.
After you verify that the group has been added, click OK.
Setting up the 2000 Compatible Access Group at the Command
Line
Adding the Everyone special group can only be done at a
command prompt. However, in the GUI, you can add the Domain Users group,
and adding that group to the Pre-Windows 2000 Compatible Access group has
almost the same effect because the Domain Users group is normally the
largest and broadest group of users. The Windows NT 4.0 RAS or RRAS server
requires a reboot. After the reboot, all domain users can be authenticated
by the RAS or RRAS server.
1.
Click Start, and then click Run.
www.tartoos.com
2.
Type
cmd,
and then click OK.
3.
At the command prompt, type net localgroup "Pre-Windows
2000 Compatible Access" everyone /add, and then press ENTER.
4.
Type
exit,
and then press ENTER.
Troubleshooting
Because servers must be restarted after you use these
procedures, you should do so when network traffic is the lightest.
The information in this article applies to:www.tartoos.com
Microsoft Windows 2000 Server SP1
Microsoft Windows 2000 Server SP2
|
مدرسة
الكمبيوتر 